After trying to use a stand-along version of Adobe ColdFusion Builder 2 (built on Eclipse) that was slow as molasses I am, instead, trying to run CFB as a plug-in to a standard Eclipse installation. So far so good. However....
I have a Logitech mouse with a ton of buttons I've customized with Logitech's SetPoint to perform common tasks such as Copy, Cut, Paste, Undo, etc....
These buttons are not working in Eclipse. I've tried messing around in the key mapping areas but it doesn't appear as if the key commands are being sent in from the mouse at all.
Here's the oddity: When I was using CFB as a stand-along install these buttons were working. Now, as a plug-in to Eclipse they are not.
Is there a setting somewhere in Eclipse to allow key commands from external apps like Logitech SetPoint?